![]() ![]() ![]() but always first check for any new firmwares. If the sensor fails to calibrate then I would first order a new sensor ( cheapest option first) if that fails then replace the main PCA. There has been a technical release from HP regarding this same issue.ġ) firstly you need to find out whether the sensor really is at fault or if there is another fault which is confusing the manual sensor output.Ī:- upgrade the firmware on the plotter ( always make sure your plotters firmware is upto date), cycle the power of the plotter and retry.ī:-use your user operating guide to take you through 'calibrating manual feed sensor' and retry.this is a quick process which sets the values for paper present/not present on the formatter.Ĭ:- if the above two have failed then order a new PCA and calibrate the sensor immediately after first initialize of new Main PCA. PROJETCUT is the last born in the Algotex’s product family, representing a unique and innovative machine able to plot as a standard plotter as well as cut paper and carton paper up to a maximum. The fault lies with the way the plotter is using the manual feed sensor, ![]() When trying to feed a new roll of paper the plotter is asking to remove the paper from manual feed even though there is none. There is a common fault on this particular printer which also affects the t770/t1200 Motorized paper tension system, patented by Algotex Constant printing speed regardless. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |